Although people feel that the mechanical hydraulic transmission is labor-saving and convenient, but at the same time they feel that it is easy to damage. The main reason is that it is not very clear about its working principle and structural characteristics, and thus its preventive maintenance methods.
1. Check the operating fluid volume first, and if necessary to increase the price of the emulsion die-casting machine prepared according to the rules of the instructions.
2. Air pressure injection is generally not allowed. If it is necessary, soft bedding must be placed in the injection chamber to prevent damage to the equipment.
3. Start the equipment according to the working principle of the next die-casting machine, and try all aspects of its actions with the empty machine.
4. Turn on the power supply, turn on the pressure storage cylinder, depress the active conditioning lever, and start the high-pressure pump. When the pump is operating normally, spread the above lever.
5. Turn on the machine main switch, operate the handle and pedal of the die-casting machine, check whether each action is normal, and confirm that all aspects are correct before the production can be carried out.
6. Pay attention to safety. It is necessary for the operator to wear protective equipment and must not stand on the surface of the die-casting type to prevent aluminum water from splashing and burn accidents.
7. It is often inquired whether various surface readings meet the requirements of the process, whether the movement of the equipment is normal, and whether it is necessary to move the total cutting wheel of the plate cooling chamber die casting machine immediately, close the storage cylinder to cut or stop the pump to check, if necessary, tell the repair personnel to repair.
8. After operation, Park according to the following times: When the equipment die casting machine is in a pressure relief condition, turn off the pump and Park, block the power supply, and close the die casting machine cutting and storage cylinder logging.
9. After the equipment is finished, the sports part of the equipment must be coated with a thin layer of mechanical oil.
