The handle of the pressure relief valve needs to be protected from the pressure relief position before the power is turned on, and then the pressure relief valve handle is placed on the pressure relief valve handle after the normal use of the motor; after the above steps, the injection needs to be performed, then before the compression The model needs to be heated to the specified temperature to be able to press into the metal solution. The operator must wear protective glasses when working, and the protective baffle is not required for the parting surface contact and the gate of the mold, and the operator must not stand. On the opposite side of the parting surface contact, in order to prevent splashing of metal liquid.
There is an open flame at the place where the working equipment is working. If the temperature of the tank exceeds the operating temperature of the equipment during operation, it needs to be cooled immediately with water. The tool is used to remove the casting from the die-casting mold, and even the clear mold and vent hole Internally adhered metal debris; when all work is completed, the oil pump needs to be stopped, and the valve is closed to turn off the power.
